Take into consideration that removing a popcorn ceiling is a dirty process. In spite of this, adequate planning may considerably cut down on the amount of cleaning required after a job. To begin, remove all of the furniture from the room. Next, cover the floor of the room as well as the lowest area of the walls (about 16 inches high) with heavy-duty plastic sheeting and secure it using masking tape.
The higher walls should also be protected, so don’t forget about it. Use extra tape to fasten the tape that you have placed around the room’s perimeter, which should be slightly below the ceiling. In order to make the procedure go more smoothly, it is possible that you may need to remove any ceiling fittings, such as fans, molding, or hanging lights.
Repeat Step 3: Spray, Wait, and Scrape
The ceiling should be broken down into manageable parts that are four feet square. First, using a garden sprayer, completely saturate the first part, and then allow it to soak for around ten to fifteen minutes. Put on your protective gear, which includes a dust mask and glasses, and then climb up a ladder to get to the area that has been moistened. It is recommended to begin scraping off the popcorn texture while holding the putty knife at a thirty-degree angle to the ceiling. Continue to proceed through the process of spraying, waiting, and scraping, moving from one region to the next until you have completely coated the whole room.
Step Four: Prime, Paint, and Complete the Project
Continue Reading in next page
